Bagaimana untuk Menulis Alamat untuk Lampu Banjir LED DMX?

Bagaimana untuk Menulis Alamat untuk Lampu Banjir LED DMX?

As our DMX decoder is developed and produced by ourselves, if you want to set addresses for our DMX LED flood lights, you should use our special address writer.

Our address writer has 4 keys. The following is their functions.

RD: read the starting address of the light fixture.
ADD+: increase the address to write.
ADD-: decrease the address to write.
LD: send command to write address.

The procedures to use our address writer:

1. Open the housing on the bottom of the light fixture, you will see a connector.

2. Unplug the connector on the back of the light, and plug the connector of the address writer to the light.

3. Our light fixture has four continuous addresses (RGBW version is four, RGB version is three). If the starting address is 1, then the rest addresses are 2, 3 and 4. Pressing the RD button on the address writer, you will get the starting address of the light fixture. If you want to write new addresses for the light fixture, please set the starting address by adjusting the buttons ADD+ atau ADD-, and finally press LD button. After finishing writing addresses, please press RD button to verify if the starting address is correct.

4. Disconnect the address writer and resume the previous connector again. Otherwise the wireless function can’t be used.

You can refer to this video.

Wireless DMX flood lights are more and more popular for no DMX cables are needed. Work and time are saved during the installation. If you have any interest in our wireless DMX flood lights, welcome to contact us for proposals and quotations.

Besides wireless DMX flood light, we also have mobile phone App controlled DMX flood light atau RF remote control flood light.

Bacaan lanjut:

Bagaimana untuk Menulis Alamat untuk Lampu Banjir LED DMX?

Tinggalkan komen Batalkan Balasan